| Electrical | Electronic and magnetic ballasts high power factor standard. Shock absorbing,
medium base lamp socket provided for HID lamps. |
|---|
| Gasket | Die-cut closed cell neoprene gasket seals die-cast housing to mounting surface. Refractor inset into housing and sealed to integral ledge with one “O” ring closed cell silicone gasket. |
|---|
| Hardware | Four captive stainless steel Torx® with center pin fasteners secure refractor/eyelid to housing. Shoulder fastener design and washer prevent refractor/eyelid stress due to over torquing. |
|---|
| Housing | One-piece heavy duty die-cast, low-copper aluminum housing. Housing flange interlocks around refractor producing maximum moisture deflection and resistance to prying. Housing provided with four standoff mounting holes. One 1/2" IPS tapped hole on back of housing. Two 1/2" IPS tapped and plugged holes on sides of housing – see Cross Section/Details. Standard housing in dark bronze TGIC polyester powder coat – 5-stage pre-treatment. |
|---|
| Installation | Wall mount standard fixture must be installed lamp base up. Standard fourpoint mounting required for Peace of Mind Guarantee®. Fixture with Horizontal Internal Shield option (ISH) may be installed in horizontal position. |
|---|
| Lens | One-piece internal-prismatic refractor (UV-stabilized, high impact, virgin injection molded polycarbonate). Nominal thickness .125". |
|---|
| Listings | UL and CUL listed for Wet Location. Luminaire tested to an IK10 impact protection rating per IEC 60068-2-75:1997-08. |
|---|
| Reflector | High efficiency textured aluminum. |
|---|