| Electrical | Available in 3500K, 4000K, and 5000K color temperatures, 80 CRI. 120-277VAC, 50/60Hz electrical input with high power factor electronic, constant-current driver (>.90 PF). Standard 0-10V dimming with 1-100% range; maximum driver source of 200 μA. Optional Motion Sensor (MS) has factory default settings of 20 minute time out, dims down to 30%.
|
|---|
| Gasketing | Die-cut, closed cell EPDM self adhesive gasket seals housing to mounting surface. Closed cell, silicone “O” ring gaskets positioned and friction secured in gasket channels of lens base and housing. |
|---|
| Hardware | Four stainless steel Torx® with center pin fasteners. |
|---|
| Housing | Marine grade die-cast aluminum. Integral heat sinks. Housing flange interlocks and wraps around lens base producing maximum moisture deflection and resistance to prying. Housing provided with four standoff mounting holes, one 3/4" NPT tapped hole on back of housing, four 3/4" NPT tapped and plugged holes on sides of housing – see Cross Section/Details. Standard black, bronze or white exterior TGIC polyester powder coat – 5-step pre-treatment. See Ordering Information for optional finishes. |
|---|
| Installation | HID units cannot be inverted to an uplight. |
|---|
| Lens | UV-stabilized, high impact resistant, virgin injection molded polycarbonate. High efficiency blondel fluted lens obscures lamp image and maximizes uniformity. Lens secured with four concealed captive Torx® with center pin fasteners. Exclusive water channeling lens design provides 360° ingress protection. |
|---|
| Lens Base/Eyelid | Lens base shields lamp from viewing angles. High impact resistant, injection molded opaque black, bronze or white polycarbonate. Optional Light Gray, Silver, Forest Green or Custom Color (see Ordering Information below) are chemically bonded, impact resistant finishes. |
|---|
| Listings | UL and CUL listed for Wet Location (listing includes Emergency Battery Pack “EL” option). UL certified IP64 per IEC 60598. All Kenall SSL Luminaires are tested to the IESNA LM-79-08 standard requiring spectroradiometric measurements for CRI and CCT as well as goniophotometric measurements for lighting distributions and total luminous flux. Luminaire tested to an IK10 impact protection rating per IEC 60068-2-75:1997-08. |
|---|
| Reflector | CFL: Full reflector/wire cover – 92% reflectivity. HID: Full reflector/wire cover. High efficiency textured aluminum. |
|---|
| Warranty | One (1) year warranty against defects in materials and workmanship. Five (5) year warranty on LED lamps and driver for defects resulting in a fixture lumen depreciation of 30% or greater. |
|---|