•  

TPDPT26

TopDek for Transportation

Main Product ImageTPDPTSSIS_HC001.png
Model #: TPDPT26
Features:
  • Fits 2-3/8" vertical tenons, 4" square and 5" round poles
  • Lumen outputs ranging from 6,500-34,000lm
  • Textured tertiary lens for unprecedented glare reduction
  • 7 distribution patterns available
  • Suitable for new installation and retrofits
Application(s):Parking Garage
Parks and Recreation
Multifamily Housing
Walkways
Schools and Universities
Transportation Platforms
Exteriors and Entryways
Lens Type(s):Drop Clear Textured Acrylic
Drop Clear Textured Polycarbonate
Flat Clear Textured Acrylic
Flat Clear Textured Polycarbonate
Lamp Type(s):LED
Size(s):26" Diameter
Listings:     
Specifications are subject to change without notice. Please consult your Kenall Customer Service for help with special requests at (800) 4 Kenall.

Technical Specifications

ElectricalReplaceable high-brightness LED array. See Ordering Information for color temperature options. 120-277VAC, 347VAC or 480VAC, 50/60Hz input with replaceable high power factor electronic constant-current driver (<20% THD, >0.90 PF). Standard 0-10V dimming with 10-100% range. Minimum 85% driver efficiency. EMC performance compliant with FCC CFR Part 15. Standard 20kV/kA surge protection to IEEE/ANSI C62.41 Cat. A.
HousingMarine-grade die-cast aluminum construction. Integral aluminum heat sink with concealed air inlet and convection fins. All power electronics removed from primary thermal path; all drivers with dedicated heatsink to exterior of luminaire. TGIC polyester powder coat finish with five-step pre-treatment; salt-spray test 1,000 hours. See Ordering Information for available finishes. Closed-cell silicone gasketing at all housing interfaces.
ListingsLuminaire is certified to UL Standards by Intertek Testing Laboratory for Wet Location. IP65 rating per IEC 60598. Luminaire is 3G tested for vibration per ANSI C136.31. For maximum efficiency, Kenall recommends TekLink™ controls. For more information, visit www.kenall.com.
Lumen DataTPDPT26 Lumen Data
MountingFits 2-3/8" vertical tenons, 4" square and 5" round poles. Secures to pole via setscrews. Pole by others. All supply connections made in center hub near pole interface. All structural hardware 304 stainless steel, or zinc plated steel Grade 8.
Note-40ºC and 40ºC ambient temperature rated unless otherwise noted.
OpticsType II, III, IV, V-Narrow Round, V-Wide Square optical distributions. Internal house-side shield available (does not impact EPA). Clear textured acrylic or polycarbonate tertiary flat lens for full-cutoff applications or injection-molded clear textured acrylic or polycarbonate tertiary drop lens for higher vertical illuminance and enhanced glare control.
PatentU.S. Patent No. D702,395, U.S. Patent No. D713,990, U.S. Patent No. 8,810,137 B2.
PhotometricsPhotometry tested to the IESNA LM-79 standard by an ILAC/ISO17025 accredited laboratory. For additional photometric data, please go to www.kenall.com.
TekLink TL1000/2000An adaptive lighting control system with wired or wireless communication between system nodes. In addition to occupancy detection and daylight harvesting, TL1000 and TL2000 feature advanced scheduling and energy management capabilities with cloud-based management of system settings, reporting and notifications.
TekLink TL50An independent lighting control system integral to the luminaire, featuring its own occupancy sensor, daylight harvesting and adjustable time-out/dimming settings. Three different programs are available, each governing system behavior in normal operation; On-to-Dim Daylighting, On-to-Off Daylighting, and Occupancy Only.
WarrantyLimited ten (10) year warranty.

Where you see this symbol, the Kenall product shown is manufactured in the USA with components purchased from US suppliers, and meets the Buy American requirements under the ARRA. Kenall has not determined the origin of its domestically purchased components or the subcomponents thereof.

Downloads

Specification Sheets

Installation Files

Photometry (IES)

Additional Resources

Advanced Lighting Solutions... Demand Kenall

START A CONVERSATION

For product information or layout assistance, connecting with us is easy:

FIND A REP

map marker icon

Search

Helpful Links
Designed and manufactured in the USA
© 2017 Kenall Manufacturing. All Rights Reserved.

This site is powered by the Northwoods Titan Content Management System.

top